Compatible Systems 1270i manual Command Line Management, Basic Configuration Guide

Page 4

Chapter 5 - Command Line Management	15
Out-of-Band Command Line Management	15
Temporarily Reconfiguring a Host for Command Line
Management	16
Setting Up Telnet Operation	16
Chapter 6 - Basic Configuration Guide	19

ETHERNET INTERFACE CONFIGURATION	19
IP Protocol	20
Required for IP	20
Suggested for IP	20
IPX Protocol	20
Required for IPX	20
Suggested for IPX	21
WAN INTERFACE CONFIGURATION	21
Internal T1 CSU/DSU (WAN 0) Physical Communications
Settings	21
Required for Dedicated Line Operation	21
Suggested for Dedicated Line Operation	21
RS-232 (WAN 1) Physical Communications Settings	21
Internal T1 CSU/DSU (WAN 0) Link Configuration	22
Required for Dedicated Line Operation	22
Suggested for Dedicated/Leased Line Operation	22
RS-232 (WAN 1) Link Configuration	22
Required for Dedicated/Leased Line Operation	22
Suggested for Dedicated/Leased Line Operation	22
Required for Dial-On-Demand Operation	22
Suggested for Dial-On-Demand Operation	23
IP Protocol	23
Required for IP	23
Suggested for IP	23
IPX Protocol	24
Required for IPX	24
Suggested for IPX	24
Internal T1 CSU/DSU (WAN 0) Link Configuration	25
Required for Dedicated/Leased Line Operation	25

ii

Image 4

Contents MicroRouter Installation Guide Page Introduction Network InstallationGetting Started Command Line Management Basic Configuration GuideAppendix a Shipping Defaults WAN InterfacesSystems Appendix E Terms and Conditions MicroRouter 1270i LED PatternsAbout the MicroRouter IntroductionIntroduction MicroRouter 1270i Installation Overview Network Installation CompatiView Software InstallationCommand Line Preparation Basic Configuration GuidePage Warranty and Service Getting StartedFew Notes Please Read The ManualsWhat You Will Need To Get Started Needed For InstallationSupplied with the MicroRouter Ethernet Connection Requirements T1 Line Connection RequirementsOther Telco Line Connection Requirements 10Base-T Twisted-Pair EthernetRS-232 Interface Network Installation Placing the RouterConnecting the Router to the Ethernet Connecting the Router to a T1 LineConnecting a Line Device to the Secondary Port Connecting to Twisted-Pair EthernetConnecting an Out-of-Band Management Console Powering Up the RouterPage CompatiView for Windows Installation and OperationSystem Requirements Transport Protocols and CompatiView Command Line Management Out-of-Band Command Line ManagementTemporarily Reconfiguring a Host for Command Line Management Setting Up Telnet OperationCommand Line Management Page Basic Configuration Guide Ethernet Interface ConfigurationIP Protocol IPX ProtocolRequired for IP Suggested for IPInternal T1 CSU/DSU WAN 0 Physical Communications Settings WAN Interface ConfigurationRS-232 WAN 1 Physical Communications Settings Internal T1 CSU/DSU WAN 0 Link Configuration RS-232 WAN 1 Link ConfigurationSuggested for Dedicated/Leased Line Operation Required for Dedicated/Leased Line OperationSuggested for Dial-On-Demand Operation IPX Protocol Frame Relay Configuration Frame Relay Dlci Mappings Required for IP Numbered InterfaceIPX Protocol Saving a Configuration File to Flash ROM Smds AddressingDefault Password Appendix a Shipping DefaultsEthernet Interfaces IP Defaults IPX DefaultsT1 CSU/DSU WAN 0 Link & Physical Defaults RS-232 WAN 1 Link & Physical DefaultsAppendix B Connector and Cable Pin Outs Pin Outs for T1 Female Connector DTEPage Power On, No Traffic Ethernet Traffic Indicators Ethernet LED BarsWAN Indicators WAN LED Bar MicroRouter 1270i LED PatternsMicroRouter 1270i Switch Settings Appendix D Downloading Software From Compatible Systems Page Appendix E Terms Conditions Appendix E Terms and ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions