Alloy Computer Products GSS-24T4SFP, GSS-16T4SFP user manual Ports, Enable Jumbo, Flow Control

Page 18

GSS Series User Manual

3.2.2 Ports

The ports configuration page is used to display the current status of each port on the switch. In this section the user can also change the speed settings and flow control of each port and Jumbo Frame support can also be enabled from this location.

Fig. 3.3

Enable Jumbo

Frames: Tick the check box to enable Jumbo Frame support on each port.

Port:Is the physical port number of the switch.

Link Status: Displays the current link status of each port. Table below displays the values shown depending on connecting device:

Link Status	Description
1000FDX	Port is running at 1000M/Full Duplex

100FDX	Port is running at 100M/Full Duplex

100HDX	Port is running at 100M/Half Duplex

10FDX	Port is running at 10M/Full Duplex

10HDX	Port is running at 10M/Half Duplex

Down	No link is present

Link Mode: Used to disable Auto-Negotiation and force the speed and duplex settings of the port. Values are Auto Speed, 10 Half, 10 Full, 100 Half, 100 Full, 1000 Full and Disable. If disable is selected the port will be fully disabled and will not function. Fibre ports only have three options Auto Speed, 1000 Full and Disabled.

Flow Control: Used to enable Flow Control on the port.

Flow Control

Status: Displays the current flow control status.

Alloy Computer Products Pty Ltd Copyright ©2007

18

Image 18

Contents GSS Series 16/24 Port Gigabit Web Managed Switch Table of Contents Electronic Emission Notices Federal Communications Commission FCC StatementAustralian C-Tick Compliance Page Introduction OverviewKey Features ChecklistOverview of the GSS range of switches User interfaces on the front panel Front Panel of the GSS-24T4SFPSystem LED’s LED IndicatorsUser interfaces on the rear panel Gigabit Copper PortsOverview of the Optional SFP Modules Alloy Part No DescriptionInstalling Optional SFP Mini-GBIC Modules Starting the GSS Series SwitchesHardware and Cable Installation Connecting the SFP Mini-GBIC Module to the ChassisCopper Ports Cable Installation Power OnFirmware Loading Cabling Requirements Multimode Fibre Cable and Modal BandwidthPage Password admin Subnet MaskWeb Management Home Overview ConfigurationMaintenance MonitoringConfiguration System InformationManagement Enable Jumbo PortsFlow Control Drop Frames after Vlan Mode Page Vlan Group Tag Based VLAN’sIngress Filtering Page Port Based VLAN’s Page Metro Mode VLAN’s Aggregation Lacp System Configuration RstpPage Radius Secret Port Admin Mode Port State Action Re-authentication 802.1x ParametersIgmp Snooping IgmpUnregistered Ipmc Flooding Igmp QueryingPort Mirroring Quality of Service Quality of Service 802.1pQuality of Service Dscp Dscp ValueFilter Rate Limit Storm Control Learn FramesFlooded Unicast Snmp Get SnmpSnmp Trap Snmp SetMonitoring Detailed StatisticsLacp Status Rstp Status Igmp Status Ping Maintenance Warm RestartFactory Default Software Upgrade Configuration File Transfer Configuration DownloadLogout ƒ Network Interface ƒ MAC Address and Self-learning 8K MAC addressƒ Cable and Maximum Length Ambient Temperature ƒ Diagnostic LEDƒ Power Requirement Dimensions