Replace or Install a Drive
Drive Installation Preparation
This section describes how to prepare to add a new drive to the library. If you are replacing a drive, follow the steps in Drive Replacement Preparation on page 8.
1.Log into the library with superuser or administrator privileges.
2.From the toolbar menu, select Configuration > Drives. The Drives screen appears.
Figure 3 The Drives screen.
3.Select Add in the location where you want to add a drive.
A Feedback Required screen prompts you to confirm that you want to add the drive.
4.Select OK.
Important Do not respond to the prompt in the Feedback Required screen or perform any other operations from the user interface (either locally or remotely) until you
complete the replacement procedure. Responding before you replace the drive will power on and configure the drive you just powered down.
Accessing the Drives
This section describes how to access the tape drives.
Spectra T200 or T380 Remove the protective cover in order to install or replace drives.
1.From the rear of the library, locate the two knurled screws securing the bottom of the cover to either side of the chassis (Figure 4).
10
Drive Installation or Replacement Instructions | 91010010 |