RSA Security 6.1 manual Should be overwritten

Table 7. Command Options for the install_rsa.sh Command (Continued)

Option	Function
-identity	Specifies whether you are installing a Primary or Replica
	RADIUS Server.
	Valid values are PRIMARY and REPLICA.
	Default value is PRIMARY.
-migrate	Indicates you want to run the RSA RADIUS Server
	migration utility (rsainstalltool), which transfers
	RADIUS settings from an older version of
	RSA Authentication Manager and registers the
	RSA RADIUS Server as a host agent.
	For information on the migration utility, refer to “Data
	Migration/Registration” on page 19.
-overwrite	Specifies that the tprsMigReg.log installation log
	file from a previous installation of RSA RADIUS Server
	should be overwritten.
-path	Specifies the path to the radius.cer, server.cer,
	radius.key, and sdconf.rec files.
	Default value is /opt.
-port	Specifies the TCP port used for administration of the
	RSA RADIUS Server.
	Default value is 1813.
-primary	Specifies the name of the Primary RADIUS Server.
	Use only when installing a Replica RADIUS Server. Do
	not use the -primaryoption if you are specifying the
	-reppkg option.
-primary_ips	Specifies the IPv4 address or addresses of the Primary
	RADIUS Server. If your Primary RADIUS Server has
	more than one network interface, you can enter as many
	as four IP addresses separated by commas.
	Use only when installing a Replica RADIUS Server. Do
	not use the -primary_ipsoption if you are specifying
	the -reppkgoption.
-primary_secret	Specifies the CCM shared secret used to authenticate
	communications between the Primary RADIUS Server
	and Replica RADIUS Servers.
	Do not use the -primary_secretoption if you are
	specifying the -reppkgoption.

30 Installing the RSA RADIUS Server September 2005