Packard Bell E680 Removing the LCD Panel, Removing the rubber covers & screws on the LCD Module

Page 20

Removing the LCD Panel

To remove the LCD panel, first remove the LCD module (see Removing the LCD Module), then perform the following steps:

1. Use pin to remove rubber cover on the LCD module as shown in Fig. 25

Fig. 25 Removing the rubber covers & screws on the LCD Module

2. Release the LCD Bezel carefully and put it aside as shown in Fig. 26

Fig. 26 Removing the LCD Bezel

M6x2.5 Black

NEC Versa E680/PB EasyNote E5 Disassembly Manual

Page 20

Image 20

Contents Versa E680 Disassembly Manual Table of contents Disassembly Instructions Reassembly InstructionsOverview Technician NotesAvoid Electrostatic Discharge Power Supply UnitHazardous Voltage Removing the Battery Removing the batteryRemoving the Hard Disk Drive Removing the Hard disk drive coverDisconnect and lift up the hard disk module as shown in Fig Removing the Memory Module Removing the screw retaining the memory module slot coverRemoving the Wireless LAN Removing the screws screw retaining the mini PCI slot coverRemoving the CPU Removing the screws retaining CPU coverUnlock CPU from CPU socket and lift up the CPU carefully Removing the optical disk drive Releasing the optical driveRemoving the Keyboard Releasing the keyboard coverRemoving the Main Board Disconnect keyboard flat cableDisconnect Touch Pad Connection as shown in Fig Flip over unit and release all screws as shown in Fig Lift up Main Board as shown in Fig NEC Versa E680/PB EasyNote E5 Disassembly Manual Removing the LCD Module Removing screws retaining LCD ModuleRemoving the LCD Panel Removing the rubber covers & screws on the LCD ModuleRemoving the LCD panel screws LCD Hock Removing the Touch Pad Top coverRemoving the Speaker Assembly DIP Switch SettingScrews Versa E680 Disassembly Manual