Maxtor ST31000424CS Shock, Operating shock, Nonoperating shock, Vibration, Operating vibration

Page 20

2.9.5Shock

All shock specifications assume that the drive is mounted securely with the input shock applied at the drive mounting screws. Shock may be applied in the X, Y or Z axis.

2.9.5.1Operating shock

The drives comply with the performance levels specified in this document when subjected to a maximum oper- ating shock of 70 Gs based on half-sine shock pulses of 2 msec. Shocks should not be repeated more than two times per second.

2.9.5.2Nonoperating shock

The nonoperating shock level that the drive can experience without incurring physical damage or degradation in performance when subsequently put into operation is 350 Gs based on a nonrepetitive half-sine shock pulse of 2 msec duration.

2.9.6Vibration

All vibration specifications assume that the drive is mounted securely with the input vibration applied at the drive mounting screws. Vibration may be applied in the X, Y or Z axis.

2.9.6.1Operating vibration

The maximum vibration levels that the drive may experience while meeting the performance standards speci- fied in this document are specified below

5–350 Hz	0.50 Gs

350–500 Hz	0.25 Gs

2.9.6.2Nonoperating vibration

The maximum nonoperating vibration levels that the drive may experience without incurring physical damage or degradation in performance when subsequently put into operation are specified below.

5–350 Hz	5.0 Gs

350–500 Hz	1.0 Gs

14	Pipeline HD.2 Series SATA Product Manual, Rev. A

Image 20

Contents Pipeline HD.2 Series Sata Revision history Revision DateContents Pipeline HD.2 Series Sata Product Manual, Rev. a List of Figures Page Introduction About the Serial ATA interface Drive specifications Specification summary tablesDrive specifications summary for 1000 Gbyte models Drive specification ST31000424CS ST31000322CSPipeline HD.2 Series Sata Product Manual, Rev. a Drive specifications summary for 500 and 250 Gbyte models Drive specification ST3500414CS ST3500312CS ST3250312CSPipeline HD.2 Series Sata Product Manual, Rev. a Default logical geometry LBA modeFormatted capacity Recording and interface technologyStart/stop times Physical characteristicsSeek time Power specifications Voltage tolerance Typical current profilesConducted noise Power-management modes Active modeIdle mode Sleep modeEnvironmental specifications Shock Operating shockNonoperating shock VibrationDrive A-weighted Sound Power Levels SWL, BA Acoustics emissionsElectromagnetic immunity Test for Prominent Discrete Tones PDTsSafety certification ReliabilityAgency certification Annualized Failure Rate AFRFCC verification Korean RRLAustralian C-Tick N176 China Restriction of Hazardous Substances RoHS Directive Environmental protectionCorrosive environment Configuring and mounting the drive Handling and static-discharge precautionsConfiguring the drive Serial ATA cables and connectorsMounting dimensions for 1000 GB models Drive mountingMounting dimensions for 500 and 250 GB models Serial ATA Sata interface Hot-Plug compatibilitySerial ATA device plug connector pin definitions Serial ATA connector pin definitionsSignal Pin Function DefinitionCommand name Command code in hex Supported ATA commandsSupported ATA commands F4H Identify Device command Word Description ValueXx07H Description if bit is set to Bit Word Bit WordWord Set Features command Set Features command valuesCode in features register A.R.T. command 3 S.M.A.R.T. commandsA.R.T. commands Seagate Technology support services InternetPresales Support Technical SupportData Recovery Services Call Center Toll-free Direct dial Warranty ServiceData Recovery Services Authorized Service Centers Index ITE Page Pipeline HD.2 Series Sata Product Manual, Rev. a Page Seagate Technology LLC