Abit NI8 SLI user manual Install CPU, Heatsink and Fan Assembly

2-2 Chapter 2

2-2. Install CPU, Heatsink and Fan Assembly

In order to protect the contact pins, please pay attention to these notices:

1.A maximum 20 cycles of CPU installation is recommended.

2.Never touch the contact pins with fingers or any object.

3.Always put on the cap when the CPU is not in use.

1.Place the board so as to let the lever hook of the socket is on your left side. Use your left thumb and forefinger to hold the lever hook, pull it away from the retention tab.

NOTE: Intel® 2.8G Dual Core CPU is not supported by NVIDIA nForce4 SLI Intel Edition processors.

4.Use your right thumb and forefinger to grasp the CPU package. Be sure to grasp on the edge of the substrate, and face the Pin-1 indicator toward the bottom-left side. Aim at the socket and place the CPU package vertical down into the socket.

2.Rotate the lever to fully open position.

5.Visually inspect if the CPU is seated well into the socket. The alignment key must be located in the notch of package.

3.Use your right thumb on the bottom-right side of the load plate and lift it up to fully open position.

6.Use your left hand to hold the load plate, and use your right thumb to peel the cap off.

NI8 SLI Series