2.6 Connecting Peripheral Devices
2.6.1 Floppy and IDE Disk Drive Connectors
Hardware Setup
The FDC1 connector connects up to two floppy drives with a
※The red line on the ribbon cable must be aligned with
Each of the IDE port connects up to two IDE drives at Ultra ATA/100 mode by one
Connect the single end (blue connector) at the longer length of ribbon cable to the IDE port of this board, the other two ends (gray and black connector) at the shorter length of the ribbon cable to the connectors of your hard drives.
※Make sure to configure the “Master” and “Slave” relation before connecting two drives by one single ribbon cable. The red line on the ribbon cable must be aligned with
|