NDC comm NWH6210, NWH2610 manual Plan the wireless network

Read through the next section ‘Plan the Network’, in order to get the best possible

performance from the InstantWave wireless network.

Step 1: Plan the wireless network	Refer to Plan the Network, page 17, for
	details
Step 2: Pre-configure the AP, WWB,		Refer to Hardware Pre-Configuration, page
or WEC before installing it		27, for details.
into an existing Ethernet		If you wish to use the default settings for a
network		simple wireless infrastructure network or
		single AP network, you may skip this step
Step 3: Install the AP, WWB, or		Refer to Hardware, page 54, for details.
WEC into the Ethernet		Note: If your network is a simple wireless
network		infrastructure network, you need only place
		the AP in a suitable location to finish the AP
		installation
Step 4: Make online configuration		Refer to Install the InstantWave
and manage the AP, WWB,		Management , page 27, and Using the
or WEC via the IWMS		InstantWave Management , page 28, for
utility		details

InstantWave 11Mbps WWB/WEC 16