HotBrick VPN 800 manual Settings Load Balance, Statistics, Interface, Buttons

	HotBrick Network Solutions
Settings – Load Balance
Load Balance	• Enable – Use this to enable your Load Balance settings. Unless this is
Configuration	checked, the other settings on this screen have no effect.
	• Balance Type – Select the desired option:
	• Bytes rx+tx – Traffic is measured by Bytes.
	• Packets rx+tx – Traffic is measured by Packets.
	• Sessions established – Traffic is measured by Sessions.
	• IP Address – Traffic is measured by IP Address.
	• Loading Share on WAN 1 – Enter the percentage (%) of traffic to be sent
	over WAN 1. If one WAN port connection has greater bandwidth than the
	other, the one with the greater bandwidth should be given a higher percentage
	of traffic than the other.
	Click the "Update" button to save your changes.
NAT	This section displays the current data about WAN 1 and WAN 2. You can use this
Statistics	information to help you "fine-tune" the settings above.
Interface	This section displays cumulative statistics.
Statistics	Use the "Restart Counters" button to restart these counters when required.
Buttons	• Update – Save the settings on this screen.
	• Refresh – Update the data on screen.
	• Restart Counters – Restart the counters used in the "Interface Statistics"
	section.

Page 21