HotBrick VPN 800 manual Settings NAT, NAT Alias

	HotBrick Network Solutions
Settings – NAT
NAT	• NAT Routing – You can enable or disable NAT through the check box. If you
Configuration	disable NAT checkbox, it will act as a bridge or Static Router. Most features
	will be unavailable.
	• TCP Timeout – Enter the desired value to use on both WAN ports. The
	default is 300.
	• UDP Timeout – Enter the desired value to use on both WAN ports. The
	default is 120.
	• TCP Window Limit – Enter the desired value to use on both WAN ports. The
	default is 0 (no limit).
	• TCP MSS Limit – Enter the required MSS (Maximum Segment Size) to use
	on both WAN ports. The default is 0 (no limit).,
	• Disable Port Translation –If some packets whose port number cannot be
	translated for special applications, you must input value in port range for
	“Disable Port Translation”
NAT Alias	• For each alias entry, the Wan IP acts as an alias IP of the host with Local Lan
	IP to internet via the specified WAN port for the specified Protocol packets

Page 41