Foxconn 661M03 user manual IRQ 3-7,9-15, NMI Default Enabled, IRQ 8 Break Suspend Default Disabled

Page 61

Chapter 3 BIOS Description

PM Wake Up Events Menu

IRQ [3-7,9-15], NMI (Default: Enabled)

This option is used to enable or disable IRQ[3-7,9-15], NMI.

IRQ 8 Break Suspend (Default: Disabled)

This option is used to enable or disable IRQ8 break suspend.

RING Power Up Control (Default: Enabled)

If this option is enable, it allows the system to resume from a software power down or power saving mode whenever there is an incoming call to an in- stalled fax/modem. This function needs to be supported by the relevant hard- ware and software. The setting values are Disabled and Enabled.

MACPME Power Up Control (Default: Enabled)

This option is used to enable or disable the system to be waken up by onboard LAN.

PCIPME Power Up Control (Default: Enabled)

This option is used to enable or disable the system to be waken up by PCI card.

PS2KB Wakeup from S3 (Default: Hot Key)

This option is used to set which action will wake up PS/2 keyboard from S3 status. The setting values are Any Key, Hot Key, Password.

PS2MS Wakeup from S3 (Default: Click)

This option is used to set which action will wake up PS/2 mouse from S3 status. The setting values are Disabled, Click, Move & Click.

Power Up by Alarm (Default: Disabled)

This option is used to set the timing of the start-up function. In order to use this function, the start-up password function must be canceled. Also, the PC power source must not be turned off. The setting values are Disabled and Enabled.

		53
	661M03 Series User Manual	53
	661M03 Series User Manual

Image 61

Contents Version Item Checklist Declaration of conformity HON HAI Precision Industry Table of Contents Chapter Driver CD Introduction Chapter Special Bios FunctionsChapter Directions for Bundled Software Page Page Page Main Features Onboard LAN Onboard 1394 optionalOnboard I/O Onboard GraphicsGreen Function Advanced FeaturesMotherboard Layout ATX power connector ATX 12V connectorPHY optional AGP slotIDE connectors Floppy disk connectorFlash Rom South Bridge controllerInstallation Instructions Installation Instructions CPU Installation of CPUInstallation of CPU Fan Installation Instructions Vendor Type CPU Qualified Vendor ListFrequence Memory Installation of DDR MemoryVender Type Size Memory Qualified Vendor ListChapter Installation Instructions Pin ATX power connector PWR1 Power SupplyPin ATX12V Power Connector PWR2 This motherboard provides the ports as below Rear Panel ConnectorsLine-in Line-out Front channels Microphone FDD Connector Other ConnectorsHDD connectors IDE1 & IDE2 Front Panel Connector FP1 USB Headers Fusb IrDA Header IR optionalAudio Connectors Cdin Fan Connectors CPUFAN, FAN1Wake-Up On LAN WOL Header F1394 optionalAudio Interface Faudio Pdif Out Connector SpdoutPCI Slots Expension SlotsAGP Slot AGP Qualified Vendor List Installing an expansion cardVender Type Video Memory CNR Slot optional Description of Jumpers JumpersClear Cmos Jumper Clscmos CNR Audio Selection Jumper J24 BIOS-Protection Jumper FwhenStarting up for the first time Powering off the computerBios Description Press TAB to show Post screen, DEL to enter Setup Enter Bios SetupStandard Cmos Features Bios FeaturesAdvanced Chipset Features Advanced Bios FeaturesPower Management Setup PnP/PCI ConfigurationsDate Standard Cmos FeaturesTime IDE Primary/Secondary Master/SlaveVideo Drive A/BHalt On Memory SuperBoot SuperBoot Default Disabled Bios FeaturesAdvanced Bios Features First/Second/Third Boot Device Default Floppy/HDD- 0/CDROM Quick Power On Self Test Default EnabledBoot Other Device Default Enabled Swap Floppy Drive Default DisabledSecurity Option Default Setup Typematic Delay Msec DefaultApic Mode Default Enabled MPS Version Control For OS DefaultTM2 Bus Ratio Default 0 Thermal Management Default Thermal MonitorTM2 Bus VID Default Advanced Chipset Features Dram Timing control Default By SPD Performance Mode Default DisabledDram CAS Latency Default 2.5T RAS Active Time tRAS Default 6TGraphic Window WR Combin Default Disabled AGP Aperture Size Default 64 MBAGP Fast Write Support Default Enabled AGP Data Rate Default AutoGraphics Engin Clock Default 133 MHz VGA Share Memory Size Default 32 MBIntegrated Peripherals Internal PCI/IDE Default Both Audio Access Interface Default EDB BusIDE Primary/ Secondary Master/Slave PIO Default Auto Primary/Secondary Master/Slave UltraDMA Default AutoUSB Ports Number Default 6 ports SIS USB Controller Default EnabledUSB 2.0 Supports Default Enabled USB Keyboard Support Default EnabledOnboard Serial Port1/2 Default 3F8/IRQ4 / 2F8/IRQ3 Onboard FDC Controller Default EnabledUart Mode Select Default Normal UR2 Duplex Mode Default HalfAcpi function Default Enabled Power Management SetupAcpi Suspend Type Default S1POS Power Management Default User DefineVideo Off Method Default Dpms Supported Video Off Option Default Susp, Stby offSwitch Function Default Break/Wake Modem Use IRQ Default AutoIRQ 8 Break Suspend Default Disabled IRQ 3-7,9-15, NMI Default EnabledRing Power Up Control Default Enabled Macpme Power Up Control Default EnabledDay of Month Alarm Month AlarmTime hhmmss Alarm Primary/Secondary IDE Default DisabledReset Configuration Data Default Disabled PnP/PCI ConfigurationsResources Controlled By Default AutoESCD PCI/VGA Palette Snoop Default DisabledPC Health Status Frequency/Voltage Control Load Optimized Defaults Load Fail-Safe DefaultsSet Password Enter PasswordExit Without Saving Save & Exit SetupSave to Cmos and Exit Y/N?Y Quit Without Saving Y/N?NChapter Install Driver Utility CD contentAccessories Browse CDInstall IDE Driver Start to Install diversInstall VGA Driver Install AGP DriverInstall DirectX Using 4-/6-Channel Audio Install USB 2.0 DriverInstalling the Audio Driver Channel Analog Audio Output Attaching SpeakersLine-out Rear channels Line-out Front channels Microphone Digital Audio Output Selecting 4- or 6-Channel SettingClick the Speaker Configuration tab Playing Karaoke Testing Each SpeakerInstall LAN Driver Install Norton Internet Security Directions for Bundled Software Using SuperStep SuperStep featuresDirections for Bundled Software Directions for Bundled Software Using SuperLogo SuperLogo featuresDirections for Bundled Software Using SuperUpdate SuperUpdate featuresDirections for Bundled Software Backup Bios to local image Directions for Bundled Software Directions for Bundled Software Update Bios On-line Click OK to update Bios Click Restart Special Bios Functions SuperSpeed SuperBoot SuperBIOS-Protect Hotkey Selection SuperRecoveryHard Disk Selection Main Menu What is a Hidden Partition?Divide Hidden Partition Divide Hidden PartitionRelease Hidden Partition Backup Cmos Setup BackupBackup Partition Table Backup Hard disk Data Back to Main RecoveryRecover Partition Table Recover Cmos SetupRecover Hard disk Data Change Password Introduction