ETA Systems ETA-20SH specifications Introduction, KEY Features, Applications

Page 3

ETA-20SH

AC Power Conditioning & Suppression Module

INTRODUCTION

The ETA Systems ETA-20SH is a 120V 60Hz AC Electrical Control Module (ECM), 20A Single Housing (SH) Power Conditioner and AC Spike Suppressor that is designed to be used as a standalone unit or in conjunction with an ETA Systems Sequence controller ETA- ECS6RM or the ETA-ECS3 up to 1000' away.

The ETA-20SH features noise filtering for removing unwanted Radio Frequency Interference (RFI) and EMI filters to reduce noise from Electromagnetic Interference (EMI) caused by items such as electric motors or switching power supplies. The benefit of these filters can be seen on video products or audibly by reducing static pops and external signal interference. If an AC spike or surge appears, the ETA-20SH also incorporates Clamping Suppression technology to prevent the unwanted energy from getting into your AV system. Other features include a Manual Bypass Switch, Incoming AC presence LED, Active LED and an AC Fault indicator. When interfaced with the ETA-ECS6RM Sequencer controller, Extreme Voltage Shutdown (EVS) Circuitry is active, along with Voltage and Current status readings.

KEY FEATURES

2 Outlets, 20A

RFI / EMI Noise Filtering

Spike & Surge Suppression, DCS Circuitry

Extreme Voltage Shutdown (EVS) Below 101V or Above 132V AC Line

AC Fault indicator

Fuse Protection @ 20A Slow Blow

Manual Bypass Switch

Incoming AC Presence LED

Active Outlet LED

Status Signals Output for Voltage and Current

APPLICATIONS

The ETA-20SH is designed to be flexible for use in a variety of applications. When used with a sequenced controller it allows the turning of equipment on and off from a remote location to save energy and to reduce an in-rush of current that stresses the main AC line. It also can be used as a standalone unit for protection against voltage surges and applies EMI/RFI filtering to clean up the AC power at the load source. The following are just a few examples of applications in which the ETA-20SH can be used:

Restaurants

Houses of Worship

Schools

Home Theaters

Office Buildings

Sports Bars

Industrial Facilities

1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.

Telephone: 800-321-6699 • Fax: 800-996-3821

– 3 –

ETAsys.com

Specifications are subject to change without notice.

Image 3
Contents ETA-20SH Table of Contents AC Power Conditioning & Suppression ModuleKEY Features IntroductionApplications ETA-20SH Safety Instructions EVS Protection EMI/RFI FiltersAC Spike Protection AC Surge ProtectionAC Mains Power Cord 9 3m, 12-gauge Panel FeaturesWiring with AN ETA-ECS6RM Sequencer Controller ECM Data Wire and DistanceUsing the ETA-20SH AS a Standalone Unit Remote Activation VIA Switch or DCV TriggerETA-ECS6RM Sequencer Controller Interface with ETA-20SH Single ETA-ECM20 Control PortRelay Contacts Wiring With an ETA-ECS3 Sequencer Controller Troubleshooting the ECM Module AS a Standalone Unit Troubleshooting the ECM Module with AN ETA-ECS3 Issue 1 Incoming AC LED on the ECM is not illuminated Troubleshooting the ECM Module with AN ETA-ECS6RMIssue 6 No Voltage Reading at the ETA-ECS6RM ETA-20SH Specifications Service Limited Warranty