10 | |||
|
|
|
|
Jumper Layout and Configuration
The figure below shows the jumper layout of the COM-1460 module.
In the figure below, the jumpers are indicated as JP followed by the jumper's number, while pin 1 of every three pin jumper is indicated by a red square pad.
JP3 |
JP2 | JP1 |
JP5
JP4
Figure 2. Jumpers on the COM-1460 module
The following jumpers are located on the module:
Three 2-pin jumpers which can be set as follows:
pin 1 and pin 2 not connected (which will be indicated as ‘Open’) pin 1 connected to pin 2 (which will be indicated as ‘Closed’)
Two 3-pin jumpers which can be set as follows:
pin 1 connected to pin 2 (which will be indicated as ‘1-2’) pin 2 connected to pin 3 (which will be indicated as ‘2-3’) no pins connected (Open). This setting is not allowed
=Open
=Closed
=
=