59 | |||
|
|
|
|
Ground the Instrument
To minimize shock hazard, the equipment chassis and enclosure must be connected to an electrical ground. The equipment is supplied with a
Do Not Operate in an Explosive Atmosphere
Do not operate the equipment in the presence of flammable gases or fumes. Operation of any electrical equipment in such an environment constitutes a definite safety hazard.
Keep Away From Live Circuits
Operating personnel must not remove equipment covers. Only Factory Authorized Service Personnel or other qualified maintenance personnel may remove equipment covers for internal subassembly or component replacement or any internal adjustment. Do not replace components with power cable connected. Under certain conditions, dangerous voltages may exist even with the power cable removed. To avoid injuries, always disconnect power and discharge circuits before touching them.
Use Caution When Exposing or Handling the CRT
Breakage of the
Do Not Substitute Parts or Modify Equipment
Because of the danger of introducing additional hazards, do not install substitute parts or perform any unauthorized modification of the equipment. Contact Eurotech technical staff or your local representative for service and repair to ensure that safety features are maintained.
Observe Dangerous Procedure Warnings
Warnings, such as the example below, precede potentially dangerous procedures throughout this manual. Instructions contained in the warnings must be followed. You should also employ all other safety precautions, which you deem necessary for the operation of the equipment in your operating environment.
Flammability
All Eurotech printed circuit boards (PCB) are manufactured by UL recognized manufacturers and have a flammability rating of
EMI Caution
This equipment generates, uses and can radiate electromagnetic energy. It may cause or be susceptible to electromagnetic interference (EMI) if not installed and used in a cabinet with adequate EMI protection.
CE Notice
This product complies with the EMC Directive (89/336/EEC). Compliance with this directive implies conformity to the following European Norms:
¾EN55022 (CISPR 22) Radio Frequency Interference
¾