EPoX Computer EP-6VBA specifications Section System Memory Configuration Memory Layout, Dimm

Installation EP-6VBA

Section 3-2

System Memory Configuration

Memory Layout

The EP-6VBA supports (3) 168-pin DIMMs (Dual In-line Memory Module). The DIMMs can be either EDO (Enhanced Data Out) or SDRAM (Synchronized DRAM).

•DIMM SDRAM may be 83MHz (12ns), 100MHz (10ns) or 125MHz (8ns) bus speed.

•If you use both 50ns and 60ns memory you must configure your BIOS to read 60ns.

•When using Synchronous DRAM we recommend using the 4 clock variety over the 2 clock.

Figure 2 and Table 1 show several possible memory configurations using both SIMM and DIMM.

DIMM 1

DIMM 2

DIMM 3

Figure 2

B a n k 0	- S y n c h ro n o u s
B a n k 1
	- E D O
B a n k 2

Total Memory	DIMM 1	DIMM 2	DIMM 3
	(Bank 0)	(Bank 1)	(Bank 2)
= 256MB	EDO/SDRAM*
	8MB, 16MB, 32MB, 64MB,	None	None
Maximum
	128MB, 256MB X 1
= 512MB	EDO/SDRAM*	EDO/SDRAM*
	8MB, 16MB, 32MB, 64MB,	8MB, 16MB, 32MB, 64MB,	None
Maximum
	128MB, 256MB X 1	128MB, 256MB X 1
= 768MB	EDO/SDRAM*	EDO/SDRAM*	EDO/SDRAM*
	8MB, 16MB, 32MB, 64MB,	8MB, 16MB, 32MB, 64MB,	8MB, 16MB, 32MB, 64MB,
Maximum
	128MB, 256MB X 1	128MB, 256MB X 1	128MB, 256MB X 1

*SDRAM only supports 8, 16, 32, 64, 128, 256MB DIMM modules. Table 1

Page 3-4