BIOS | |
|
|
|
|
4-6 Load Setup Defaults
The “LOAD SETUP DEFAULTS” function loads the system default data directly from ROM and initializes the associated hardware properly. This function will be necessary only when the system CMOS data is corrupted.
4-7 Integrated Peripherals
ROM PCI/ISA BIOS(2A6LGPAA)
INTEGRATEDPERIPHERALS
AWARD SOFTWARE, INC.
|
|
|
|
|
| |
OnChip IDE Channel0 | : Enabled |
| Onboard Parallel Port | : 378/IRQ7 | ||
OnChip IDE Channel1 | : Enabled |
| Onboard Parallel Mode | : ECP/EPP | ||
IDE Prefetch Mode | : Enabled |
| ECP Mode Use DMA | : 3 | ||
Primary Master | PIO | : Auto |
| Parallel Port EPP Type | : EPP1.9 | |
Primary Slave | PIO | : Auto |
| Onboard Legacy Audio | : Enabled | |
Secondary Master PIO | : Auto |
| Sound Blaster | : Disabled | ||
Secondary Slave PIO | : Auto |
| SB I/O Base Address | : 220H | ||
Primary Master | UDMA | : Auto |
| SB IRQ Select | : IRQ 5 | |
Primary Slave | UDMA | : Auto |
| SB DMA Select | : DMA 1 | |
Secondary MasterUDMA | : Auto |
| : Disabled | |||
Secondary Slave UDMA | : Auto |
| : | |||
Init Display First | : PCI Slot |
| FM Port | : Disabled | ||
|
|
|
| Game Port | : Enabled | |
Onboard FDD Controller | : Enabled |
|
|
| ||
Onboard Serial Port 1 | : Auto | Esc : Quit | é ê è ç : Select Item | |||
Onboard Serial Port 2 | : Auto | F1 | : Help | |||
UART 2 Mode |
| : HPSIR | ||||
| F5 | : Old Values | (Shift) F2 : Color | |||
IR Function Duplex | : Half | |||||
F7 : Load Setup Defaults |
| |||||
TX, RX inverting enable | : No, Yes |
| ||||
|
|
| ||||
|
|
|
|
|
| |
|
|
|
|
|
| |
Figure 8: Integrated Peripherals
Note: If you do not use the Onboard IDE connector, then you will need to set Onboard Primary PCI IDE: Disabled and Onboard Secondary PCI IDE: Disabled
Note: The Onboard PCI IDE cable should be equal to or less than 18 inches (45 cm.).
IDE Prefetch Mode:
Enable prefetching for IDE drive interfaces that support its faster drive accesses. If uou are getting disk drive errors, change the setting to omit the drive interface where the errors occur. Depending on the configuration of your IDE subsystem, this field may not appear, and it does not appear when the Internal PCI/IDE field, above, is Disabled.
The Choice: Enabled, Disabled.
Page