| Installation |
|
|
|
|
Section 3-3
Installing a Pentium II or Pentium III Processor
The
Please have ready the following list of components so that we may install the processor onto the motherboard.
1.Heat sink support (top/bottom piece)
2.Pentium® II processor heat sink
3.Intel Pentium II Processor
OK, now that you have all of your components ready, we can start.
First, please refer to figure 6 below, and follow the direction to lift up the fixed foldable pentium® II Retention Mechanism. This
One thing must be kept in your mind that please make sure to lift upright the foldable parts of the Retention module to fit and install CPU properly.
Figure 6
Now we are going to install the heatsink support base piece (figure 7) onto the motherboard. There is both a large and small hole (figure 8) so that the base will only fit in one direction. This piece needs to be pushed into the holes firmly until it is seated.
Now we are ready to install the SEC Cartridge (Pentium® II Processor) into the Retention Module. The SEC Cartridge is mounted by sliding the SEC Cartridge into the Retention Module and letting it slide all the way down. Once it reaches the bottom make sure you press firmly on SEC cartridge to firmly secure into the Slot 1 Socket.
Page