Envision Peripherals LM914 user manual

Page 9

LM914

Preparing To Install The Optional Wall Mount Arm (Not Included)

This monitor can be attached to a wall mounting arm or bracket you can purchase separately from Ergotron (www.ergotron.com). Turn the power OFF then dis-connect the cables from the monitor before performing the procedure below. Lay the monitor face down on a soft surface.

1.Remove wall mounting hole cover.

2.Remove the cable cover.

3.Remove the 4 screws holding the base to the back of the monitor.

4.Remove the base.

INSTALLATION INSTRUCTIONS (cont)

8

Image 9

Contents LCD Monitor LM914FCC Class B Radio Frequency Interference Statement Precautions PrecautionsLM914 Checking the Contents of the Package FeaturesBefore YOU Operate the Monitor Special Notes on LCD MonitorsPowercord Installation InstructionsPower Source Swivel BasePreparing to Install the Cables Installations InstructionsCable Connections Installation InstructionsLM914 Attaching The Optional Wall Mount Arm not supplied Adjusting the Viewing AngleLM914 Operating Instructions General InstructionsExternal Controls Power Indicator Auto Adjust button / ExitVolume Control Front Panel ControlOSD Message HOW to Adjust a SettingAdjusting the Picture Plug & Play DDC1/2B Feature Using the Right Power CordPlug and Play Technical Support FAQ LM914 No Signal Error Message & Possible SolutionUnsupported Mode TRY Different Video Card Setting ResolutionLM914 For First Time Install HOW to Install the DRIVER-DISK INF & ICM FileAppendix SpecificationsUL, CSA, FCC, T ÜV/GS, CE VGA Factory Preset Timing TablePIN no Description PI N no Connector PIN AssignmentTmds Data Warranty Statement LM914