SpeedStream Dual USB/Ethernet Router User’s Guide
Model 5667
Make sure the PC and target router are on the same IP subnetwork or the target router is reachable through a router on your LAN. They can, however, be on different networks if IP routing is off.
Check Network TCP/IP properties under Windows 95 and the control panel of the TCP/IP driver installed.
Troubleshooting: ATM Connectivity
The ATM physical layer provides a mechanism for monitoring cell delineation. The cell delineation function allows the identification of cell boundaries in the payload. The emweb:EwSysModeCurrentLC; software monitors Out of Cell Delineation (OCD) alarms which indicate that there are errors found in the payload. If the OCD condition persists for greater than 2.5 seconds, it will cause the DSL line to retrain.
You can test the health of the ATM link by manually sending Operations and Maintenance (OAM) cells over a specified virtual connection. This command requires the specification of:
•OAM loopback cell type - either F4 or F5
•Transmit over a single LAN segment (one hop) or
•VPI/VCI number of connection to transmit OAM cell over
The response section of the web page will indicate if an OAM reply has been received for the transmitted OAM cell.
Login Password Problems
You have been prompted for the login password and received the following message: Login Password is invalid.
Type the correct password and press enter. Remember that the password is
If you have forgotten the password, you must reset the login password.
DSL Line Training
If the DSL line is retraining frequently, it may be that there are errors in the ATM traffic that is causing
The DSL LED on the front of the router will indicate green when the DSL line has been operational for 10 seconds.
Check the DSL Status page for details.
50