Directed Electronics K10 manual Function

Page 12
Function

Channel Number

Function

Wire Color

1

Arm/Disarm/Panic

 

 

 

 

2

Silent Mode/Remote Override/Trunk Release

RED/WHITE

 

 

 

3

Remote engine start or Other Accessory

 

 

 

 

4

Arm only

 

 

 

 

5

Disarm only

 

 

 

 

6

Panic only

 

 

 

 

7

Auto-learn Single Button Arm/Disarm Configuration*

 

 

 

 

8

Auto-learn Standard Configuration*

 

 

 

 

9

Delete all remotes

 

 

 

 

**NOTE: For Auto Learn Configurations, see Remote Configurations section of this guide.

Channels #4-6: Channels 4 through 6 are used to assign the arm, disarm and panic functions to sep- arate buttons on the remote control. Teaching a button to Channel 4 erases all information about that remote from memory. Any auxiliary functions that are desired will have to be reprogrammed. Similarly, if the remote is set up to use the separate arm, disarm and panic channels and a button from that remote is entered into channel one, the remote will be erased from memory, and the system will only recognize the button that was entered into Channel 1.

Channel #9: If any button from a known remote is programmed to Channel 9, all remotes will be erased from memory and the system features will revert to the default settings. This is useful in cases where the one of the customer's remotes is lost or stolen. This will erase any lost or stolen remotes from the system's memory. It can also be used to start from scratch if the remote buttons were programmed incorrectly.

To exit the learn routine:

One long horn honk indicates that programming has been exited.

➤Ignition is turned off.

➤Override switch is pressed too many times.

➤More than 15 seconds elapse between steps.

13

Page 11 Page 13
Image 12
Page 11 Page 13
Contents installation guide Model K10table of contents door lock harness H4, wire connection guidemodule programming system features menus feature descriptions power-up wiring quick reference guideprimary harness H1 wire connection guide primary harness H1 wiring diagramprimary harness wire descriptions H1/1 ORANGE - Ground-When-Armed OutputH1/2 WHITE - Parking Light Output H1/3 WHITE/BLUE - Channel 3 OutputH1/4 BLACK/WHITE - 200 mA Domelight Supervision Output H1/6 BLUE - 200 mA Second Unlock Output H1/8 BLACK - Chassis Ground ConnectionH1/9 YELLOW + Ignition Input H1/10 BROWN - Horn Honk OutputH1/11 RED +12V constant power input H1/12 RED/WHITE channel 2, 200mA - outputdoor lock harness H4, wire connection guide override switch, 2-pin BLUE plugperipheral plug-in harnesses LED, 2-pin WHITE plugmodule programming Pro Security Programmer interface, 3-pin portTo enter the learn routine 4. Release. The Override switch can now be released The Override switch is pressed too many timesThe learn routine will be exited if The ignition is turned on More than 15 seconds elapses between programming stepssystem features menus feature descriptionsremote coding Function remote configurations standard configurationsingle button arm/disarm configuration power-up wiring quick reference guide Pro Security Programmer Override Switch 3-Pin 2-Wire DoorLock Harness Ungo Pro Security 661 W. Redondo Beach Blvd Gardena, Ca 800-GO-CLARIONGet Started Get Protected 2003 Directed Electronics, Inc. - All rights reserved GK10
Top Page Image Contents