Directed Electronics K10 manual H1/11 RED +12V constant power input

Page 6

H1/11 RED (+)12V constant power input

Before connecting this wire, remove the supplied fuse. Connect to the positive battery terminal or the constant 12V supply to the ignition switch.

NOTE: Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the fuse in the har- ness for this purpose. This fuse protects the module itself.

H1/12 RED/WHITE channel 2, 200mA (-) output

When the system receives the transmitter code controlling Channel 2 for longer than 1.5 seconds, the red/white wire will supply an output as long as the transmission continues. This is often used to oper- ate a trunk/hatch release or other relay-driven functions.

IMPORTANT! Never use this wire to drive anything but a relay or a low-current input! The transistorized output can only supply 200 mA of current. Connecting directly to a solenoid, motor, or other high-current device will cause it to fail.

Image 6

Contents installation guide Model K10module programming system features menus feature descriptions table of contentsdoor lock harness H4, wire connection guide power-up wiring quick reference guideprimary harness wire descriptions primary harness H1 wire connection guideprimary harness H1 wiring diagram H1/1 ORANGE - Ground-When-Armed OutputH1/2 WHITE - Parking Light Output H1/3 WHITE/BLUE - Channel 3 OutputH1/4 BLACK/WHITE - 200 mA Domelight Supervision Output H1/9 YELLOW + Ignition Input H1/6 BLUE - 200 mA Second Unlock OutputH1/8 BLACK - Chassis Ground Connection H1/10 BROWN - Horn Honk OutputH1/11 RED +12V constant power input H1/12 RED/WHITE channel 2, 200mA - outputperipheral plug-in harnesses door lock harness H4, wire connection guideoverride switch, 2-pin BLUE plug LED, 2-pin WHITE plugmodule programming Pro Security Programmer interface, 3-pin portTo enter the learn routine The learn routine will be exited if The ignition is turned on 4. Release. The Override switch can now be releasedThe Override switch is pressed too many times More than 15 seconds elapses between programming stepssystem features menus feature descriptionsremote coding Function remote configurations standard configurationsingle button arm/disarm configuration power-up wiring quick reference guide Pro Security Programmer Override Switch 3-Pin 2-Wire DoorLock Harness Get Started Get Protected Ungo Pro Security 661 W. Redondo Beach Blvd Gardena, Ca800-GO-CLARION 2003 Directed Electronics, Inc. - All rights reserved GK10