Directed Electronics K10 door lock harness H4, wire connection guide, LED, 2-pin WHITE plug, H2/A

door lock harness (H4), wire connection guide

H2/A	___	Green	(-) Lock, (+) Unlock Output
	___
H2/B		Empty	Unless Using Resistor Interface
	___
H2/C		Blue	(-) Unlock, (+) Lock Output

Important! The door lock outputs are low current and should not be attached directly to any high current device; they are only to be used to activate relays

peripheral plug-in harnesses

LED, 2-pin WHITE plug

The LED operates at (+) 2 volt DC and plugs into the two-pin WHITE port. Make sure the LED wires are not shorted to ground as the LED will be damaged. Multiple LED’s can be used, but they must be wired in series. The LED fits into a 9/32-inch mounting hole. Be sure to check for clearance prior to drilling the mounting hole.

NOTE: Never use a BLUE LED in combination with a RED LED.

DIA-41

override switch, 2-pin BLUE plug

The override switch should be accessible from the driver’s seat. It plugs into the BLUE port on the side of the unit. Consider how the button will be used before choosing a mounting location. Check for rear clearance before drilling a 9/32-inch hole and mounting the button.

8