Directed Electronics K10 manual remote configurations, standard configuration

Page 13

remote configurations

remote configurations

The transmitters can be programmed with the standard or single button arm/disarm configurations by using the Auto Learn functions in the Remote Coding.

standard configuration

A remote that uses the standard configuration operates similarly to many factory keyless entry remotes. A standard configuration remote allows arming, disarming, and panic mode activation with separate buttons. When programmed for standard configuration using the Channel 8 Auto-learn configuration, the transmitter buttons are assigned to the following functions:

operates	Arm only
operates	Disarm only
operates	Channel 2 and Silent Arm/Disarm
operates	Panic only
and	operate Channel 3

single button arm/disarm configuration

When programmed for single button arm/disarm configuration using the Channel 7 Auto-learn con- figuration, the remote buttons are assigned to the following functions:

operates Arm/Disarm/Panic

operates Channel 2 and Silent Arm/Disarm

and	operate Channel 3

14

Image 13

Contents Model K10 installation guidedoor lock harness H4, wire connection guide table of contentsmodule programming system features menus feature descriptions power-up wiring quick reference guideprimary harness H1 wiring diagram primary harness H1 wire connection guideprimary harness wire descriptions H1/1 ORANGE - Ground-When-Armed OutputH1/3 WHITE/BLUE - Channel 3 Output H1/2 WHITE - Parking Light OutputH1/4 BLACK/WHITE - 200 mA Domelight Supervision Output H1/8 BLACK - Chassis Ground Connection H1/6 BLUE - 200 mA Second Unlock OutputH1/9 YELLOW + Ignition Input H1/10 BROWN - Horn Honk OutputH1/12 RED/WHITE channel 2, 200mA - output H1/11 RED +12V constant power inputoverride switch, 2-pin BLUE plug door lock harness H4, wire connection guideperipheral plug-in harnesses LED, 2-pin WHITE plugPro Security Programmer interface, 3-pin port module programmingTo enter the learn routine The Override switch is pressed too many times 4. Release. The Override switch can now be releasedThe learn routine will be exited if The ignition is turned on More than 15 seconds elapses between programming stepsfeature descriptions system features menusremote coding Function standard configuration remote configurationssingle button arm/disarm configuration power-up Pro Security Programmer Override Switch 3-Pin 2-Wire Door wiring quick reference guideLock Harness 800-GO-CLARION Ungo Pro Security 661 W. Redondo Beach Blvd Gardena, CaGet Started Get Protected 2003 Directed Electronics, Inc. - All rights reserved GK10