Dell C600 Removing the Microprocessor Module, C r o p r o c e s s o r M o d u l e s

Microprocessor Module

M i c r o p r o c e s s o r M o d u l e s

NOTICE: Hold the microprocessor down while turning the cam screw to prevent intermittent contact between the cam screw and microprocessor.

perpendicular	pin-1 corner	perpendicular
		screwdriver
screwdriver
	processor die	ZIF socket
ZIF socket	(do not touch)	cam screw
		ck
cam screw
		l
		o
l
o
c
k

type I ZIF socket type II ZIF socket

Removing the Microprocessor Module

NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.

NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.

NOTICE: Read "Preparing to Work Inside the Computer" before performing the following procedure.

1 Remove the hard drive.

2 Remove the keyboard assembly.

NOTICE: To ensure maximum cooling for the microprocessor, do not touch the heat transfer areas on the thermal cooling assembly. The oils in your skin reduce the heat transfer capability of the thermal pads.

pin-1 corner

processor die (do not touch)

Removing and Replacing Parts

47