Dell 600m manual Removing the Microprocessor Module, Installing the Microprocessor Module

Back to Contents Page

Microprocessor Module

Dell™ Inspiron™ 600m Service Manual

Removing the Microprocessor Module

CAUTION: Before performing the following procedures, read the safety instructions in your Owner's Manual.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.

NOTICE: Do not touch the processor die. Press and hold the microprocessor down on the substrate on which the die is mounted while turning the cam screw to prevent intermittent contact between the cam screw and microprocessor.

NOTICE: To avoid damage to the microprocessor, hold the screwdriver so that it is perpendicular to the microprocessor when turning the cam screw.

1.Follow the instructions in "Preparing to Work Inside the Computer."

2.Remove the keyboard.

NOTICE: To ensure maximum cooling for the microprocessor, do not touch the heat transfer areas on the microprocessor thermal-cooling assembly. The oils in your skin reduce the heat transfer capability of the thermal pads.

3.Remove the microprocessor thermal-cooling assembly.

NOTICE: When removing the microprocessor module, pull the module straight up. Be careful not to bend the pins on the microprocessor module.

4.To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.

1screwdriver (perpendicular to microprocessor)

2ZIF-socket cam screw

3ZIF socket

4pin-1 corner

NOTE: The ZIF-socket cam screw secures the microprocessor to the system board. Take note of the arrow on the ZIF-socket cam screw.

5.Lift out the microprocessor module.

Installing the Microprocessor Module