Dell 600m manual Back to Contents

Page 26

1back center of the palm rest

2touch pad connector

3system board connector

4computer base

6.Turn the computer over and remove the nine M2.5 x 8-mm screws.

1 M2.5 x 8-mm screws (9)

NOTICE: Carefully separate the palm rest from the computer base to avoid damage to the palm rest.

7.Starting at the back center of the palm rest, use your fingers to separate the palm rest from the computer base by lifting the inside of the palm rest while pushing in on the outside.

Back to Contents Page

Image 26
Contents July 2003 Rev. A01 Before You Begin Preparing to Work Inside the ComputerScrew Identification Recommended ToolsComputer Orientation Page Back to Contents Flashing the Bios Bluetooth Card Remove the display assemblyReplacing the Color Insert Cover Color Insert CoverRemoving the Color Insert Cover Removing the Microprocessor Module Installing the Microprocessor ModuleMicroprocessor Module Back to Contents Display Assembly and Display Latch Display AssemblyPage Display Bezel Display PanelRemove the display assembly Remove the display bezel Display LatchRemoving the Docking Doors Installing the Docking DoorsDocking Doors Back to Contents Fan Hard Drive Back to Contents Keyboard Back to Contents Base Latch Modem Modem Modem cable Palm Rest Back to Contents Video Connector Pin Assignments for I/O ConnectorsUSB Connector Parallel Connector18-25 Reserve Battery Speakers System Board Removing the System BoardInstalling the System Board System Components Installing the Microprocessor Thermal-Cooling Assembly Microprocessor Thermal-Cooling AssemblyRemoving the Microprocessor Thermal-Cooling Assembly March 2003 Rev. A00 Memory Module, Mini PCI Card, and Modules Memory ModuleMini PCI Card Page Modules If the Device Security Screw Is Not InstalledIf the Device Security Screw Is Installed Back to Contents
Related manuals
Manual 122 pages 25.24 Kb Manual 122 pages 22.12 Kb Manual 176 pages 31.73 Kb