Processor Thermal-Cooling Assembly

Back to Contents Page

Processor Thermal-Cooling Assembly

Dell™ Inspiron™ 1501 Service Manual

Removing the Processor Thermal-Cooling Assembly

Replacing the Processor Thermal-Cooling Assembly

CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.

NOTICE: To help prevent damage to the system board, remove the main battery (see Before Working Inside Your Computer) before working inside the computer.

Removing the Processor Thermal-Cooling Assembly

1.Follow the instructions in Before You Begin.

2.Remove the hinge cover (see Removing the Hinge Cover).

3.Remove the keyboard (see Removing the Keyboard).

4.Remove the display assembly (see Removing the Display Assembly).

5.Remove the palm rest (see Removing the Palm Rest).

6.Loosen in consecutive order the four captive screws, labeled "1" through "4," that secure the processor thermal-cooling assembly to the system board.

NOTICE: To ensure maximum cooling for the processor, do not touch the heat transfer areas on the processor thermal-cooling assembly. The oils in your skin reduce the heat transfer capability of the thermal pads.

7. Lift the processor thermal-cooling assembly and remove it from the system board.

1	captive screws (4)	2	processor thermal-cooling assembly

Replacing the Processor Thermal-Cooling Assembly

NOTE: If you are replacing the thermal-cooling assembly without removing and replacing a new processor, you can place the new thermal pad directly on any existing thermal pad already installed on the thermal-cooling assembly. It is not necessary to remove an existing pad or to clean the surface.

1.Place the processor thermal-cooling assembly over the processor.

2.Tighten the four captive screws, labeled "1" through "4," in consecutive order.