Dell 1501 owner manual Replacing the Memory Modules

1 memory module 2 securing clips (2)

Replacing the Memory Module(s)

NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface.

NOTE: To get maximum performance/dual-channel memory bandwidth capability, both memory module connectors must contain memory modules and the modules must be of the same size and configuration.

NOTE: If a memory module is not installed properly, the computer does not boot.

1.Align the notch in the module edge connector with the tab in the connector slot.

2.Slide the module firmly into the slot at a 45-degree angle, and lower the module until it clicks into place. If you do not feel the click, remove the module and reinstall it.

3. Replace the memory module/modem cover and tighten the captive screws.

NOTICE: If the memory module/modem cover is difficult to close, remove the module and reinstall it. Forcing the cover to close may damage your computer.

4.Insert the battery into the battery bay, or connect the AC adapter to your computer and an electrical outlet.

5.Turn on the computer.

As the computer boots, it detects the additional memory and automatically updates the system configuration information.

Back to Contents Page