Removing the Docking Board
1.Follow the procedures in Before Working Inside Your Computer
2.Remove:
a.Battery
b.Bottom Cover
3.Perform the following steps as shown in the illustration:
a.Disconnect the antenna cables from the docking board [1].
CAUTION: Exercise caution while disconnecting the antenna cables. Improper removal may result in damage/breakage of the antenna cables.
b.Unroute the antenna cables [2].
c.Remove the screws that secure the docking board [3].
d.Flip the docking board [4].
e.Lift the release tab [5].
f.Disconnect the docking board connector cable from the system board [6].
4.Lift and remove the docking board from the computer chassis.
Installing the Docking Board
1.Connect the docking board connector cable to the system board.
2.Flip the docking board and seat it on the slot.
3.Tighten the screws to secure the docking board.
4.Route the antenna cables.
5.Connect the antenna cables to the docking board.
6.Install:
a.Bottom Cover
b.Battery
7.Follow the procedures in After Working Inside Your computer
15