Installing the I/O Board
1.Place the I/O board on the computer.
2.Tighten the scews that secure the I/O board to the computer.
3.Connect display assembly cable to the computer.
4.Connect the I/O cable to the computer.
5.Tighten the screw that secures the I/O board.
6.Slide the I/O board into its place on the computer.
7.Close the I/O bay press latch door.
8.Install:
a.Bottom Cover
b.Optical Drive
c.Hard Drive
d.Battery
9.Follow the procedures in After Working Inside Your computer
Removing the Storage Connector
1.Follow the procedures in Before Working Inside Your Computer
2.Remove:
a.Battery
b.Hard Drive
c.Optical Drive
d.Bottom Cover
3.Perform the following steps as shown in the illustration:
a.Lift the locking tab [1].
b.Disconnect the storage connector cable [2].
c.Remove the screw that secures the storage connector [3].
d.Lift the storage connector from the computer [4].
27