Installing the SSD Bracket
1.Place the SSD bracket on the computer.
2.Tighten the screws that secure the SSD connector.
3.Affix the adhesive tape to the computer.
4.Connect the SSD bracket cable to the computer.
5.Install:
a.Bottom Cover
b.Optical Drive
c.Hard Drive
d.Battery
6.Follow the procedures in After Working Inside Your computer
Removing the USH Board
1.Follow the procedures in Before Working Inside Your Computer
2.Remove:
a.Battery
b.Hard Drive
c.Optical Drive
d.Bottom Cover
3.Perform the following steps as shown in the illustration:
a.Lift the locking tab [1].
b.Disconnect the USH board cables from the connectors [2].
c.Remove the screws that secure the board [3].
d.Lift and flip the board at an angle to access the smart card cable at the bottom [4].
e.Lift the locking tab [5].
f.Disconnect the smart card cable and release the USH board from the computer chassis [6].
29