To replace the hard drive in the hard drive bay:
1Follow the procedures in "Before You Begin" on page 109.
2Turn the computer over, and remove the hard drive screws.
1
2
1 | screws (2) | 2 | hard drive |
NOTICE: When the hard drive is not in the computer, store it in protective antistatic packaging. See "Protecting Against Electrostatic Discharge" in the Product Information Guide.
3Slide the hard drive out of the computer.
4Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE: Use firm and even pressure to slide the drive into place. If you use excessive force, you may damage the connector.
5Slide the hard drive into the bay until it is fully seated.
6Replace and tighten the screws.
7Install the operating system for your computer. See "Restoring Your Operating System" on page 102.
8Install the drivers and utilities for your computer. See "Reinstalling Drivers and Utilities" on page 100.