Dell 1090 manual Replacing the Display Panel, Removing the Display Cable

Page 21

1

screws (8)

2

display back cover

 

 

 

 

Replacing the Display Panel

1.Follow the instructions in Before You Begin.

2.Align the display back cover on the display panel and snap it into place.

3.Replace the eight screws that secure the display back cover to the display panel.

4.Replace the display-panel hinge brackets.

5.Align the holes on the display-panel hinge brackets with the guide posts on the display frame and place it in position.

6.Route the display cable through the routing guide.

7.Replace the six screws that secure the display panel to the display frame.

8.Replace the display hinges (see Replacing the Display Hinges).

9.Replace the display bezel (see Replacing the Display Bezel).

10.Replace the hinge caps (see Replacing the Hinge Caps).

11.Replace the display assembly (see Replacing the Display Assembly).

CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer.

Display Cable

Removing the Display Cable

1.Follow the instructions in Before You Begin.

2.Remove the display assembly (see Removing the Display Assembly).

3.Remove the hinge caps (see Removing the Hinge Caps).

4.Remove the display bezel (see Removing the Display Bezel).

5.Remove the display hinges (see Removing the Display Hinges).

6.Remove the display panel (see Removing the Display Panel).

7.Turn the display panel over.

8.Disconnect the touch-screen cable from the connector on the display panel.

CAUTION: The two display-panel hinges are part of the display cable and cannot be removed separately.

9.Push the display-panel hinges out to release the tabs on the hinges from the slots on the display panel.

10.Lift the display-panel hinges and pull the pull-tab to disconnect the display cable from the connector on the display panel.

Image 21
Contents Page Removing the Ambient-Light Sensor Board Ambient-Light Sensor BoardReplacing the Ambient-Light Sensor Board Battery Removing the BatteryReplacing the Battery Back to Contents Recommended Tools Before You BeginTurning Off Your Computer Before Working Inside Your ComputerBack to Contents Click Enter a Tag Flashing the BiosRemoving the Camera Module Camera ModuleReplacing the Camera Module Coin-Cell Battery Removing the Coin-Cell BatteryReplacing the Coin-Cell Battery Back to Contents AC-Adapter Connector Removing the AC-Adapter ConnectorReplacing the AC-Adapter Connector Back to Contents Display Assembly Removing the Display AssemblyDisplay Replacing the Display Assembly Display Bezel Hinge CapsRemoving the Hinge Caps Replacing the Hinge CapsDisplay Hinges Replacing the Display BezelRemoving the Display Hinges Display Panel Replacing the Display HingesRemoving the Display Panel Page Display Cable Replacing the Display PanelRemoving the Display Cable Replacing the Display Cable Removing the Hard-Drive Assembly Hard-Drive AssemblyReplacing the Hard-Drive Assembly Processor Fan and Heat-Sink Assembly Removing the Processor Fan and Heat-Sink AssemblyReplacing the Processor Fan and Heat-Sink Assembly Back to Contents Connector Covers Removing the Connector CoversReplacing the Connector Covers Page Removing the Keyboard KeyboardReplacing the Keyboard Page Label Door Removing the Label DoorReplacing the Label Door Removing the Memory Module Memory ModuleReplacing the Memory Module Removing the Mini-Cards Wireless Mini-CardsReplacing the Mini-Cards Back to Contents Removing the Palm-Rest Assembly Palm-Rest AssemblyReplacing the Palm-Rest Assembly Back to Contents Speakers Removing the SpeakersReplacing the Speakers Page Removing the System Board System BoardReplacing the System Board Entering the Service Tag in the Bios Back to Contents