1 | left hall-sensor cable connector | 2 | screws (4) |
| | | |
3 | palm-rest assembly | 4 | right hall-sensor cable connector |
| | | |
5 | touch-pad cable connector | | |
| | | |
CAUTION: Carefully separate the palm-rest assembly from the computer base to avoid damage to the palm-rest assembly.
9. Using a plastic scribe, carefully pry out the palm-rest assembly along the rear edge and then ease the palm-rest assembly from the computer base.
1 | palm-rest assembly | 2 | plastic scribe |
| | | |
10. Lift the palm-rest assembly off the computer base.
Replacing the Palm-Rest Assembly
1.Follow the instructions in Before You Begin.
2.Align the palm-rest assembly on the computer base and gently snap the palm-rest assembly into place.
3.Slide the touch-pad cable, left hall-sensor cable, and right hall-sensor cable into the connectors on the system board and press down on the connector latches to secure them.
4.Replace the four screws that secure the palm-rest assembly to the computer base.
5.Replace the keyboard (see Replacing the Keyboard).
6.Replace the six screws to the computer base.
7.Replace the label door (see Replacing the Label Door).
