Dell G2410H, G2410T appendix Setting Up the Monitor, Attaching the Stand, Connecting Your Monitor

Back to Contents Page

Setting Up the Monitor

Dell™ G2410H Flat Panel Monitor User's Guide

Attaching the Stand

Connecting the Monitor

Organizing the Cables

Attaching the Soundbar (Optional)

Removing the Stand

Wall Mounting (Optional)

Attaching the Stand

NOTE: The stand is detached from monitor when it is shipped from the factory.

Remove the monitor cover and place the monitor on it.

1.Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.

2.Lower the stand so that the monitor mounting area snaps onto the stand.

Connecting Your Monitor

CAUTION: Before you begin any of the procedures in this section, follow the Safety Instructions.

To connect your monitor to the computer:

1.Turn off your computer and disconnect the power cable.

2.Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your computer. Do not connect both cables on the same computer. Use both the cables only when they are connected to two different computers with appropriate video systems.

Connecting the White DVI Cable

Connecting the Blue VGA Cable