Common Problems

AAmbient light Sensor Lens

BShortcut Key 1 / Up button

CShortcut Key 2 / Down button

DOSD menu / OK button

EBack / Exit button

FPower button (with power light indicator)

4.Carefully inspect the screen for abnormalities.

5.Press the E button on the front panel again. The color of the screen changes to red.

6.Inspect the display for any abnormalities.

7.Repeat steps 5 and 6 to inspect the display in green, blue, and white colored screens.

The test is complete when the white screen appears. To exit, press the E button again.

If you do not detect any screen abnormalities upon using the built-in diagnostic tool, the monitor is functioning properly. Check the video card and computer.

The following table contains general information about common monitor problems you might encounter and the possible solutions.

Common Symptoms	What You		Possible Solutions
	Experience
No Video/ Power LED off	No picture	•	Ensure that the video cable connecting the monitor and the computer is properly connected and secure.
		•	Verify that the power outlet is functioning properly by using any other electrical equipment.
		•	Ensure that the power button is depressed fully.

No Video/ Power LED on	No picture	•	Increase brightness & contrast controls using the OSD.
	or no	•	Perform monitor self-test feature check.
	brightness	•	Check for bent or broken pins in the video cable connector.
		•	Run the built-in diagnostics.

Poor Focus	Picture is	•	Perform Auto Adjust using the OSD.
	fuzzy,	•	Adjust the Phase and Pixel Clock controls using the OSD.
	blurry, or	•	Eliminate video extension cables.
	ghosting	•	Reset the monitor to Factory Settings.
		•	Change the video resolution to the correct aspect ratio (16:9).

Shaky/Jittery Video	Wavy	•	Perform Auto Adjust using the OSD.
	picture or	•	Adjust the Phase and Pixel Clock controls using the OSD.
	fine	•	Reset the monitor to Factory Settings.
	movement	•	Check environmental factors.
		•	Relocate the monitor and test it in another room.

Missing Pixels	LCD screen	•	Cycle power on-off.
	has spots	•	Pixel that is permanently off is a natural defect that can occur in LCD technology.
		•	Run the built-in diagnostics.

Stuck-on Pixels	LCD screen	•	Cycle power on-off.
	has bright	•	Pixel that is permanently off is a natural defect that can occur in LCD technology.
	spots	•	Run the built-in diagnostics.

Brightness Problems	Picture too	•	Reset the monitor to Factory Settings.
	dim or too	•	Auto Adjust using the OSD.
	bright	•	Adjust brightness & contrast controls using the OSD.
		•	Keep any object clear from the intelligent ambient light sensor.

Geometric Distortion	Screen not	•	Reset the monitor to Factory Settings.
	centered	•	Auto Adjust using the OSD.
	correctly	•	Adjust brightness & contrast controls using the OSD.
		NOTE: When using '2: DVI-D', the positioning adjustments are not available.

Horizontal/Vertical Lines	Screen has	•	Reset the monitor to Factory Settings.
	one or more	•	Perform Auto Adjust using the OSD.
	lines	•	Adjust Phase and Pixel Clock controls using the OSD.
		•	Perform monitor self-test feature check and determine if these lines are also in self-test mode.
		•	Check for bent or broken pins in the video cable connector.
		•	Run the built-in diagnostics.
		NOTE: When using '2: DVI-D', the Pixel Clock and Phase adjustments are not available.
Synchronization Problems	Screen is	•	Reset the monitor to Factory Settings.

Dell G2410T, G2410H Common Problems, Common Symptoms What You Possible Solutions Experience

AAmbient light Sensor Lens

FPower button (with power light indicator)

Common Problems

Common Symptoms

What You

Possible Solutions

Experience