Dell 2407WFP-H C, 2407WFP-HC appendix Using the Front Panel Buttons, Input Source Select

Page 33

1AC power cord connector

2DC power connector for Dell™ Soundbar

3DVI connector

4VGA connector

5Composite video connector

6S-Video connector

7Component video connectors

8USB upstream port

9USB downstream ports

To connect your monitor to the computer perform the following steps/instructions.

Turn off your computer and disconnect the power cable.

Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your computer. Do not use both cables on the same computer. The only case in which both cables can be used is if they are connected to two different computers with appropriate video systems. (Graphics are for illustration only. System appearance may vary).

Connect the upstream USB port (cable supplied) to an appropriate USB port on your computer .

Connect USB peripherals to the downstream USB ports (rear or side) on the monitor. (See rear or bottom view for details.)

Plug the power cables for your computer and monitor into a nearby outlet.

Turn on the monitor and computer.

If your monitor displays an image, installation is complete. If it does not display an image, see Solving Problems.

Use the cable holder on the monitor stand to neatly organize the cables.

NOTE: If your computer does not support the DVI connector, you can leave the cable unconnected or remove it.

NOTE: For USB peripherals already connected to your computer, changing the USB connection to your monitor is not necessary.

Using the Front Panel Buttons

Use the control buttons on the front of the monitor to adjust the characteristics of the image being displayed. As you use these buttons to adjust the controls, an OSD shows their numeric values as they change.

A

Input Source Select

Use Input Source Select button to select between five different video signals that may be connected to your monitor.

1.VGA input

2.DVI-D input

3.S- Video input

4.Composite video input

5.Component video input

As you cycle through the inputs you will see the following messages to indicate currently selected input source. It may take seconds for the image to appear.

or

or

If either VGA or DVI-D input is selected and both VGA and DVI-D cables are not connected, a floating dialog box as shown

or

If either S-Video or Composite input is selected and both cables are not connected or the video source is turned off, the sc have an image. If any button is pressed (except power button), the monitor displays the following message:

Image 33
Contents About Your Monitor Rotating Your Monitor Dell 2407WFP-HC Flat Panel Monitor Users GuideAbout Your Monitor Front ViewBack View Right side Side ViewBottom View Monitor SpecificationsGeneral Left sidePreset Display Modes ResolutionFlat Panel Video Supported ModesElectrical Physical CharacteristicsPower Management Modes EnvironmentalPin Assignments Pin Number Pin Side of the Connected Signal Cable DVI ConnectorUniversal Serial Bus USB Interface Transfer speed Data Rate Power ConsumptionCard Reader Specifications Pin Number Pin Side of the connectorPin Number Pin Side of the Signal Cable Plug and Play Capability Caring for Your MonitorFCC Identification Information AppendixAntigua and Barbuda Contacting DellAomen Country Code853Australia Sydney Aruba0011 Austria ViennaHardware Warranty Phone Support Customer ServiceBolivia BrazilCosta Rica ColombiaCzech Republic Prague Denmark CopenhagenEcuador Dominican RepublicEl Salvador Finland HelsinkiGuatemala GrenadaGuyana Hong KongTechnical Support Ireland CherrywoodGeneral Italy MilanLatin America Korea SeoulLuxembourg Malaysia PenangMontserrat MexicoNetherlands Antilles Netherlands AmsterdamPuerto Rico PortugalSt. Kitts and Nevis St. LuciaCountries Southeast Asian and PacificSpain Madrid Sweden Upplands VasbyTurks and Caicos Islands Trinidad/TobagoBracknell UruguayFinancial Services Virgin IslandsVenezuela If you have a DellT desktop with no internet access Setting Up Your MonitorSetting Up Your Monitor Setting Up Your Monitor Setting Up Your Monitor Dell 2407WFP-HC Flat Panel Monitor Rotating Your Monitor Changing the Rotation of Your MonitorRotating Your Operating System Connecting Your Monitor Input Source Select Using the Front Panel ButtonsUsing the OSD Accessing the Menu SystemPIP / PBP Select Icon Menu and Submenus Auto AdjustExit DescriptionColor Settings Color setting submenu for VGA/DVI-D inputVGA/DVI-D Image Modes Display Settings Use the and buttons to adjust for best image qualityPIP Settings Menu SettingsOSD Warning Messages When PIP/PBP activatedUsing the Dell Soundbar Optional VGA / DVI-D input Video InputVGA DVI-D Video Composite Soundbar Attachment to the Monitor Solving Problems Troubleshooting the MonitorCommon Problems Check if DVD player is Hdcp compliant Video ProblemsUniversal Serial Bus USB Specific Problems Product Specific ProblemsTroubleshooting the Dell Soundbar Specific Symptoms What YOU Experience Possible SolutionsProblem Troubleshooting the Card ReaderSolution CauseUsing the Tilt, Swivel and Vertical Extension Using Your Adjustable Monitor StandAttaching the Stand Organizing Your CablesVertical Extension Removing the Stand
Related manuals
Manual 2 pages 40.13 Kb