Dell 2407WFP-HC, 2407WFP-H C appendix Using the OSD, Accessing the Menu System, PIP / PBP Select

B

PIP / PBP Select

Use this button to activate PIP (Picture-in-Picture) / PBP (Picture-by-Picture) modes adjustment.

Pressing this button continually cycles the monitor through the following modes : OFF- ->PIP- ->PBP. You will see the fo messages corresponding to the mode selected.

→

→

C

D

D

,E

E

F

OSD Menu / Select

Brightness/Contrast Hot Key

Down (-) and Up (+)

Auto Adjust

Power button (with power light indicator)

The MENU button is used to launch the on-screen display(OSD) and select the OSD Menu. See Accessing the Menu System

Use this button for direct access to the "Brightness" and "Contrast" control menu.

Use these buttons for navigating and adjusting the slider-bar(decrease/increase ranges) controls in the OSD.

Use this button to activate automatic setup and adjust menu. The following dialog appears on a black screen as the monit to the current input:

Auto Adjust In Progress

Auto Adjustment allows the monitor to self-adjust to the incoming video signal. After using Auto Adjustment, you can furth monitor by using the Pixel Clock (Coarse) and Phase (Fine) controls under Image Settings.

NOTE: Auto Adjust will not occur if you press the button while there are no active video input signals or attached cables.

The green LED indicates the monitor is on and fully functional. An amber LED indicates DPMS power save mode.

The Power button turns the monitor on and off.

Using the OSD

Accessing the Menu System

NOTE: If you change the settings and then either proceed to another menu, or exit the OSD menu, the monitor automatically saves those changes. The cha settings and then wait for the OSD menu to disappear.

1. Push the MENU button to launch the OSD menu and display the main menu.

Main Menu for Analog (VGA) Input

Or

Main Menu for non Analog (non VGA) Input