Datamax Ex2 manual Interface Connection

Page 4

Interface Connection

The printer can be connected to the host via a USB, serial or parallel cable. The Printer will automatically connect to the first port (USB, serial or parallel) that transmits valid data. After this connection has been made, the printer’s power must be cycled Off and On to change the interface connection.

USB Connection: The USB Interface is supported in Windows 95 and greater. Depending upon the operating system of your host computer, installation may differ slightly.

Parallel Connection: The parallel interface requires a standard parallel cable with a 36 pin male connector.

3

Image 4
Contents Page Printer Overview Connecting Power Printer ConnectionsInterface Connection Page Ethernet Setup Automatically Obtain an IP via a Dhcp ServerIP Address Subnet Mask Gateway Page Configure Settings via The Printers Internal Web Pages Page Installing the Media Roll Loading MediaPage Loading the Peel and Present Option Page Fan-fold / External Supply Loading Media Setup Windows Printer Driver Media SetupContinuous Label Media Reflective Mark Label Media Status Light Flashing Paused or Error Condition Printer ResetPrinter Operation Status Light On Normal OperationMaintenance Mode Installing the Windows Driver Windows DriverSetup Tab Stock Important NotesInstalling DMXConfig Printer Configuration Utility DMXConfigDMXConfig Features Cleaning Intervals Maintenance and AdjustmentsArea Method Interval Printhead Cleaning Printhead Pressure Adjustment Low Medium HighMedia Guide Adjustment Too Tight Correct