CPG SP40 manual Printing the Test, Self Test

Page 28

•Print one of the Printer Setup Forms (Configuration Menu or Program1/Program2 Menu) or the Offset Tuning Form. See “ Printing the Printer Setup Forms” later in this manual

•Insert a filled-in Printer Setup Form to set the corresponding Setup values.

Printing the Test Page

The Self Test page is useful to test, if the printer has been correctly installed, and allows to see the current parameter settings.

1.With the printer in the Setup Mode, insert a single sheet in A4 or Letter format.

2.The printer loads the sheet and stops.

3.Press the ON LINEkey again.

The printer prints the Self-Test page. Check that the printout is correct. The following printout example shows the Printer Setup default values.

Once the self-test is finished, the printer remains in Setup Mode.

SELF TEST

SP-40 :Code Version Vx.x xxxxxxxx CharGen:xxxxxxxx ver. x.xx

CONFIGURATION SETUP

PROGRAM	progr.1	AUTOFEED SIGNAL	disabled
ERROR BUZZER	1 beep	SLCT-IN SIGNAL	disabled
JOB BUZZER	no beep	IGNORE PE	enabled
SECURITY MODE	enabled	BUFFER CONTROL	XON/XOFF
PASSBOOK TYPE	vertical	ROBUST XON	enabled
GET EDGE QUOTE	1/2”	WORD LENGTH	8 bit
INTERFACE TYPE	automatic	BAUD RATE	9600 bps

24

Image 28

Contents SP40 Compuprint Products Information FCC Notes Canadian D.O.C. Radio Interference RegulationTable of Contents Printer Presentation High reliability paper handlingPage Unpacking the Printer Printer Parts Front ViewInside View Rear View Printer Installation Choosing a Suitable LocationInstalling the Power Cable Always use a grounded outletInstalling the Ribbon Cartridge Page Page Page Page Close the printer cover Paper Handling Loading PaperPage Operator Panel STATION2 Function KeysOn Line Leds Software Driver Selection Connection to the Host Setting the Interface Parameters Parallel InterfacePrinter Setup Entering the Printer Setup ModePrinting the Test Self TestHonor CTS Program Setup VERT.POS VERT.ADJ Printing the Printer Setup Forms Configuration Setup Program Offset Tuning Setup Filling in the Printer Setup Forms Do not use pencilsSetup Parameters Restore to MFGError Buzzer ProgramContinuous SLCT-IN Signal Interface TypeHonor CTS Input BufferXON/XOFF+DTR Security Mode Robust XONWord Length Baud RateProtocol FontFast LQ HorizontalForm Length ExampleRight Margin TOP MarginIBM C-SET IBM CompressEpson C-SET Nation C-SETCode GOST, TASS, MAZOWIA, CP437SLPORTUGAL, SPAIN1, DEN/NORW FRANCE, ITALY, SWE/FIN, SwissLine Mode LF=LF, CR=CR Wrap ModeReset with Eject CR=LF+CRNo the printer performs only the reset command CUT Sheet Eject Offset AdjustmentsPrint Impact Offset Tuning Setup Page = First Print Position Reading the Preprinted Forms Printer Setup Overview Printer OFFTroubleshooting Paper ProblemsPage Paper Damaged after Printing Ribbon Cartridge Problems Installing the Ribbon CartridgePaper Specifications Use paper matching the indicated characteristicsCuts Sheets Print AreaPassbooks ThicknessPassbooks with Horizontal Fold Passbooks with Vertical Fold Technical Specifications ER24SKbytes buffer EPA Energy Star