Printer Setup
The Printer Setup is used to configure the printer parameters and to print a Self Test page, to check the settings and the printer installation, and to perform the Print Offset Tuning.
The default configuration of this printer matches most of the commonly used environments, but it may be necessary to change some printer parameters. With this printer you print the forms for the setup, you fill them in, and then you insert them back into the printer for reading.
Once the printer reads the form, the new values are set.
The following is the complete description of the Setup Procedure.
Entering the Printer Setup Mode
To enter the Printer Setup Mode press and hold the ON LINEkey pressed for at least 1 second while powering the printer on. The printer enters the Setup Mode.
The three lower leds are unlit:
1
EJ ECTLQ
= lit | = unlit |
You can now:
•Print the Self Test. See “ Printing the Self Test
” later in this manual.
23