Cobalt Networks PS-8300 user manual DIP Switches on the MFC-8310-N, Buttons on the MFC-8310-N

DIP Switches on the MFC-8310-N

The following DIP Switches are located on the MFC-8310-N controller card.

DIP_1 Switch

DIP_1 switch disables the audio alarm signal as follows:

•ON — This setting disables the audio alarm.

•OFF — This setting enables the audio alarm.

DIP_2 to DIP_7 Switches

DIP_2 to DIP_7 switches are not used.

DIP_8 Switch

DIP_8 switch sets the default IP Address of the MFC-8310-N controller card as follows:

•ON — This setting enables the card to use the default IP Address of 192.168.1.1.

•OFF — This setting enables the card to use the IP Address configured by the user.

Buttons on the MFC-8310-N

The following buttons are located on the MFC-8310-N controller card.

Alarm Mute/Bootload Button

When a card in the frame is reporting an error, pressing the Alarm Mute Button will mute the audio alarm until another fault condition occurs. This button is also used as a bootload button for factory service in the unlikely event of a complete card failure. The bootload process is further described in pages 36-37, “Service Information.”

Reset Button

This button is used to restart both of the onboard processors: the fan control processor and the communications processor. The communications processor requires approximately 30 seconds to restart and re-establish network communications.

MFC-8310-N LEDs

The front edge of the MFC-8310-N, and the CFM-8310 in the frame door, have LED indicators for cooling module fan, alarm, and communication activity.

The CFM-8310 provides LED and Alarm switching controls to the front edge of the 8310 frame door. LED displays and descriptions are provided in the following table:

Page 32 of 40 8310 User Manual • (V 1.0.1)