Citizen Systems CBM-291 user manual Value, BIT Function

(24) Transmitting the printer status (ESC v) Code : [1B]h + [76]h

Current printer status is transmitted..

•Status sent out consists of 1 byte whose content is as in the table below.

•In DTR/DSR control, after receptible state of the host (DSR signal being in SPACE state)

is confirmed, only 1 byte is transmitted. In XON/XOFF control, DSR signal state not being confirmed, only 1 byte is transmitted.

•In DTR/DSR control, when the host is in unreceptible state(DSR signal being in

MARK state), it waits until receptible state is created.

•In paper end (paper near end) status, this command may be unreceptible state due to BUSY state. Remarks. This command is valid only for serial interface model.

		VALUE
BIT	FUNCTION	0	1
0	Not defined
1	Not defined
2	Paper end	With paper	Without paper
3	Not defined
4	Not used	Fixed to 0	-
5	Not defined
6	Not defined
7	Not defined

(25) Transmitting the status of Peripheral Equipment (ESC u n) Code : [1B]h + [75]h + n

* {n = 0}

Current status of connector pin No.3 is transmitted.

•"n" means the followings.

n (Hex)	Condition
0	Drawer Kick Connector No. 3

•Status transmitted consists of 1 byte whose content is as in the table below.

•Any equipment has not been connected to this connector, Bit 0 of n is always "1".

•In DTR/DSR control, after receptible state of the host (DSR signal being in SPACE state) is confirmed, only 1 byte is transmitted. Further, in XON/ XOFF control, DSR signal state not being confirmed, only 1 byte is transmitted.

•In DTR/DSR control, when the host is unreceptible state (DSR signal being in MARK state), it keeps waiting until receptible state is created.

		VALUE
BIT	FUNCTION	0	1
0	Not defined
1	Not defined
2	Paper end	Paper remains	Paper out
3	Not defined
4	Not used	Fixed to 0	-
5	Not defined
6	Not defined
7	Not defined

Remarks :This command is valid only for serial interface mode.

CITIZEN 39