|
| |
|
| |
| ||
(1) | Power Cord | Insert the plug end into an electric outlet. The |
|
| the equipment and should be easily accessible. |
(2) | Power Switch | Power is supplied to the printer by turning this switch on. |
(3) | Power Lamp | This lights up when the power switch is “ON” and goes out when turning “OFF”. |
(4) | SEL / ALARM Lamp | This lights up when the printers is in SELECT state ( |
|
| in DESELECT state |
The printer can print out the data only when this lamp is on.
This lamp may blink on the following occasions.
1)When the paper roll in coming to
In this status, if you want to print out the data in the
2)When the printer is in alarm state, this lamp keeps blinking at interval of 1/4 second. Remove the cause for alarm and press the SEL switch. (or
(5) | LF Switch | Paper feeding is performed when this switch is pressed |
|
| (in DESELECT status only). |
|
| This is used when inserting the paper and for spacing up etc. |
(6) | SEL Switch | When this switch is pressed, the printer enters SELECT |
|
| When pressed again, the printer enters DESELECT |
|
| This switch is also used when clearing an alarm condition. |
(7) | I / F Connector | Connects through a cable to a computer etc. Please be certain that power to both |
|
| the printer and the computer are turned off when connection is made. |
(8) | Cash Drawer or Paper Winder Connector | |
|
| To be used to control the P.O.S. cash drawer or paper winder by |
|
| DIP SWITCH setting |
|
| When this connector is used for each drawer solenoid voltage 24V, |
|
| register over 36 , for paper winder, use CBM model |
Connector Pin Assignment
Pin No | Signal Name | Function |
|
|
|
1 | Vp | DC24V, 0.8A or less |
2 | VL | Solenoid |
3 | PG | GND |
4 | PG | GND |
Connector : Printer side
:
CITIZEN | 9/38 |