EtherFast® 10/100 LAN Cards
Novell NetWare Server Setup
Overview
The EtherFast Card network driver will be automatically installed during all of the following NetWare installation procedures. During the setup you may want to refer to your NetWare Installation Manual for help.
•To Install the NetWare 5.x Server software on your PC, go to page 43.
•To Install the NetWare 4.x Server software on your PC, go to page 42.
•To Install the NetWare 3.12 Server software on your PC, continue below.
Note: If, after any of these installations, the operating system asks you for a slot number, NetWare needs to know which PCI slot your card has been installed to. The slot variable can be added to the driver line as shown in the example below:
load c:\lne100\lne100tx.lan slot = 3 frame = ethernet_802.2 name = nserv
bind ipx to nserv net = 15
In this example, the card is in slot 3, the frame is Ethernet_802.2, the net value is 15 (arbitrary) and the name is nserv (arbitrary name).
Installing a 3.12 Server
1.Create a directory in the DOS partition of your file server called LNE100.
2.Copy the following files from the EtherFast Card Driver Disk to your file server's new LNE100 directory:
a:\netware\server\nw31x\NBI31X.NLM
a:\netware\server\nw31x\MSM31X.NLM
a:\netware\server\nw31x\ETHERTSM.NLM
a:\netware\server\nw31x\LNE100TX.LAN
3.Following the Load LAN Driver Module instructions in your Novell NetWare 386 v3.12 manual, start NetWare and configure the server (if you haven’t already).
4.Load the above LAN drivers using the LOAD command.
41