ATS HILT 9000 manual Function Controls Summary, Button Description Comments

HILT 9000 - Inductive Loop Tester		9
Function Controls Summary
BUTTON	DESCRIPTION	COMMENTS
LOOP	Used to measure L, Q, and RDC	The loop must be
	of the loop. Q is measured up	disconnected from the
	to 15. If Q>15, use Q button to	system to run this test
	obtain the actual value of Q
Q	Used to measure high Q	The loop must be
	values (when Q is >15)	disconnected from the
		system to run this test
∆ L	Used to measure change of	The loop must be
	inductance	disconnected from the
		system to run this test
DETECTOR	Used to measure operating	The loop must be
	parameters of the loop	connected from the
	system: VP-P, Oscillating	system to run this test
	Frequency, and Mode
SET FREQ.	Used to select operating
	frequency to measure L and Q
! and "	Used in SET FREQ mode to
	increase and decrease
	frequency in 1KHz steps.
POWER	Used to turn the unit on and	The tester can be
	off.	turned off at any time
		during or after a test