IPS 1000 Series VoIP Gateway
5.Dial “9507#”；Assuming you are modifying for China (The last 2 digits are the regional ID)
6.Dial “971#”；Sets the new regional ID.
7.Hang up the phone. The device will be updated with the new region setting after it restarts (restart time is about 10 seconds)
9.1.2.System console settings (Only for 4/8/16 ports)
Enter configuration commands, one per line. End with CNTL/Z
This command resets the system with factory defaults.
All system parameters will revert to their default factory settings. All static and dynamic addresses will be removed.
Reset system with factory defaults, [Y]es or [N]o? Yes
Attention:
Before Changing the Region ID, the system has to be reset to the default value. Therefore this step should be done first.
The following instruction may keep the IP address unchanged after reset: “delete nvram keep_ip”
9.2.IP Address Settings
We recommend using a traditional phone to configure the unit’s parameters, as this is the easiest way. The following two sections contain the procedures used to configure the IPS unit according to how you obtain your IP address (Static IP; DHCP or PPPoE).
Attention:
Every time you set a parameter item and press the “#” key to complete it, a successful setting will be confirmed by three equal tones in succession. If your setting is unsuccessful you will be prompted with one long tone.
15