IPS 1000 Series VoIP Gateway
digits are accepted by phoneset only, you need a mapping between characters and digits. You can find them at section 14.4 Mapping table of characters used in PPPoE.
Example user name：83721@hinet.net，Password：123ab，The procedure is below
1.Connect the phone to IPS
2.When CPU/ACT is light, pick up the phone and press
3. | ##0000 | ；You will hear 3 short tones. |
4. | 0938333732314068696*465742*46*46574# | ；Set user name：83721@hinet.net |
5. | 103132336162# | ；Set password is 123ab |
6. | 981# | ；Save and restart. |
2.Use Console to configure (Only for 4/8/16 ports Gateway)
Enter configuration commands, one per line. End with CNTL/Z
This command resets the system. System will restart operation code agent. Reset system, [Y]es or [N]o? Yes
3.Use WEB Interface to configure:
You can configure the user name and password by using WEB interface. Follow the steps to finish configuration.
Step 1: Using a traditional phone set to configure the web management password and phone number You will need to use a web browser to perform the PPPoE settings through the IPS unit’s web based management interface. To enter the web based management interface you must have a previously configured password. Follow the next procedure to setup your password and phone number.
1.Connect the IPS unit to a suitable Power source.
2.Connect a traditional phone set to the “Phone” connector located on the rear panel.
3.When the CPU/ACT light is on, pick up the phone. You should hear the dialing tone.
4. | ##0000 | ; you should hear three short tones. |
5. | 15123 | ; “123” is the web management password. |
6. | 010# | ; “0” is to enable “manual” IP mode. |
18