Tour of the MultiMix USB2.0, Line Inputs Channels 5

2 A Tour of the MultiMix USB2.0

Line Inputs (Channels 5 – 8)

Unlike channels 1 – 4, the line inputs on channels 5 – 8 are stereo inputs that have left and right inputs. If you’re using one of these channels as a mono input, plug your instrument into the left input. Channels 5 – 8 don’t have the extra gain found on channels 1 – 4 because most line-level instruments don’t require the extra boost. Synthesizers and other electronic instruments will work especially well on these channels. These inputs are also good for connecting CD players or tape decks, as these audio sources don’t require extra gain.

PHONE Jack

The headphone jack accepts 1/4” jacks. If your headphones are 1/8”, you can find a 1/8” to 1/4” adapter in most electronics stores.

AUX RETURNS

These are the 1/4” jacks where you connect the outputs of an external effects processor or other audio source. Each aux return gives you 15dB of gain that can be controlled by the AUX RET A and EFFECTS / AUX RET B LEVEL knobs in the mixer’s output section.

AUX SENDS

And this is the 1/4” jack where you connect the cable that’s going into the input of an external effects processor. The aux sends give you 10dB of gain that can be controlled in the AUX section of each channel input.

2-TRACK

The 2-TRACK IN and OUT jacks are standard RCA jacks. You’ll use the OUTs for mixing to a tape deck or other recorder. With the INs you can bring in a signal, which can be monitored and even added to the main mix via the 2TK TO MIX switch in the master section of the mixer.

The 2-TRACK INPUT is blended with any signal coming back from a computer over the USB2.0 connection.

MAIN MIX OUT

These 1/4” jacks are where the signal on the main mix bus leaves the mixer. From there you can send it to a recorder or a PA system. The level of this signal is controlled by the MAIN MIX fader.

CTRL RM OUT

You can use these 1/4" jacks to send the control room signal to the input of the amplifier driving your monitors or headphones.

If you are using an effects device with only a mono output, plug it into the left return of STEREO AUX RETURN. It will appear in the center of the stereo spectrum, and not to the left.